EVANGELION
EVANGELION
Published 2016-05-27T16:42:28+00:00
good on this occasion I bring you something real scale manufacture a couple of years ago,
3d had so bother modify it a bit to 3D printing, hope you like.
not developed in detail for lack of time. but I think I stay pretty well, at that time, had little to work with skethup
time: 4h:20min
material: 8m40cm
remember to use mirror
real picture: I take four days carving foam piece in hand.
The Evangelion cockpit requires two of each stl, one as it is and the other mirrored. The only part that does not require this is the central piece (please check the pictures). Glue both parts of the main cockpit together, don't use a fast setting glue, you will probably need to make small adjustments, after being satisfied with the alignment, I used tape to secure both halves until the glue was set. Add a couple drops of superglue to the central piece and place it in the main cockpit, all of the other pieces don't require glue, they just snap together, but you can add a couple of superglue drops to set them permanently in place.
Date published | 27/05/2016 |
Time to do | 220 - 250 minutes |
Material Quantity | 55g |
Dimensions | 177mm x 70,8mm x 88mm |
Technology | FDM |