Sheridan PGP2 Feed Plug (Reinforced)
Sheridan PGP2 Feed Plug (Reinforced)
Published 2019-08-30T14:47:24+00:00
This feed plug replaces the fragile speed feed on the Sheridan PGP2. It greatly improves feeding and requires no permanent modifications to the marker. This feed plug is held in place by two #015 o-rings rather than requiring a groove cut in the feed tube. The plug is extended and knurled for a better grip.
Materials Required:
Two (2) #015 o-rings
One (1) 2" carriage bolt
One (1) washer for carriage bolt
One (1) nut for carriage bolt
Blue thread locker
When assembling, it is recommended to cut down the excess bolt length with a cutoff wheel or a hacksaw. If your rear washer is too wide for the recess, remove material from the washer, not from the plug. The end cap is a press fit.
Date published | 30/08/2019 |