-Now on MyMiniFactory!
-Vent holes are now wider.
-This version need supports. Only from the base.
-V5 Still available. That version doesn't need supports.
-Fixed wrong angle that caused bad printings. Now is 45°
-The Nozzle is now centered.
-Added more holes and
-Added a version with a space to see printing.
-Added original SLDPRT file to allow easy remixing.
This is the third version, the nozzle is not centered by a few milimeters. To adjust the gap from the bed to the duct, simply adjust the fan entirely with the screws. Printed with PLA with no problems whatsoever, but still recommended to print in ABS.