Anvil, but taller
1,126
views
50
downloads
1
collection
0 comments
Loading comments...
Anvil, but taller
3D
Published 2019-12-22T01:00:12+00:00
6
0
Add to Collection
Description
A not too well made model of an anvil, the only problem that has, is that is taller than usuall.
License
Printing Details
I used supports at a 70 degree angle, this gives it a better finishing after you remove the supports. Check that the little rectangle and circle at the top wont start printing in the air, I recommend 10% of infill in Lines so that won' t happen. Also, if you enable ironing looks better. Don't print it very fast, because the tip might not stick correctly and it will string, 50mm/s is enough.
Technical Information
Date published | 22/12/2019 |
More Information
Object Parts