Balancer for Propellers and Spinners
Balancer for Propellers and Spinners
3D
Published 2019-10-15T15:30:12+00:00
Prop & spinner balancer "inspired by" Dubro Tru-Spin :)
Print settings:
bok1.stl and bok2 stl
layer height: 0.2 mm
bottom layers: 5
top layers: 4
outline/perimeter shells: 4
infill: 20%
mocowanie.stl and mocowanie_nakretka.stl:
layer height: 0.1 mm
bottom layers: 3
top layers: 3
outline/perimeter shells: 3
infill: 20%
other parts:
layer height: 0.2 mm
bottom layers: 3
top layers: 3
outline/perimeter shells: 3
infill: 20%
In addition to the printed parts you will also need:
8x M3 bolt 16 mm long
8x M3 nut
8x plastic screw 3x9mm
4x ball bearing 3x8x3mm
4x M10 widened washer (10,5 mm inner diameter, 30mm outer diameter), edges of the washer should be rounded, it would also be good to check if the washer is balanced
4x steel rod 3mm diameter, 150mm long,
And it works :D
https://www.youtube.com/watch?v=UNz5FRcxoVI
As you can see, this propeller badly needs balance ;)
To attach the propeller (or spinner) to the balancer you can use a rod with a diameter such as the propeller hub, or "universal axle".
It will be needed:
Steel rod 3mm diameter,
Spring approx. 3,5 inner diameter.
os1.stl (printed with 0,1mm layer height)
os2.stl (printed from TPU)
| Date published | 15/10/2019 |