Bases for 15mm / 18 mm / 1:100 miniatures
Bases for 15mm / 18 mm / 1:100 miniatures
3D
Published 2021-03-01T11:02:33+00:00
A set of bases useful for many popular 15-18mm historical wargames.
These bases have 8x1mm rebates which readily accept any of my pre-based miniatures.
Magnets:
These bases have holes which can accept a 3x1 or 3x1.5mm magnet, allowing the use of a simple sheet metal (tinplate or steel) sabot to keep your formations together and make movement on the table more convenient when fielding large units. Installation of magnets is simple; providing minimal shrinkage and effective washing of the printed part, magnets should be a snug push fit. If printing at 50 microns, there will be a four layer thick membrane at the base of the hole which neatly contains the magnet while allowing for it to be very close to metal surfaces below.
Printing:
The bases are offered in two variants, one for FDM printers, and another set with a beveled underside which allows them to be printed directly against the build plate of an SLA printer (the bevel helps to counteract the 'elephant's foot' effect).
Sizes:
All bases are 3mm thick, and have the following dimensions:
20x25mm Single miniature (Commanders etc.)
20x25mm Two miniatures (Skirmish base)
20x25mm Two rank, two file
30x25mm Two rank, three file
40x25mm Two rank, four file
60x25mm Two rank, six file
For SLA - print directly on the build plate.
| Date published | 01/03/2021 |
| Support Free | YES |