Bathtub Drain Hair Catcher Plug
Bathtub Drain Hair Catcher Plug
3D
Published 2020-07-10T12:10:42+00:00
Bathtub Drain Hair Catcher Plug: This filter fits inside your bathtub drain to catch hair. It fits a 35mm (1 3/8") drain. Use your slicer to re-size this model according to the size of your bathtub drain. You may use your bathtub plug to measure the size of your drain. The model is inserted into the drain. Water is allowed to pass to the center of the plug, where hair wraps around the plug and is easily removed with the plug. The model features a rounded top that doesn't hurt your feet, A rounded bottom for easy insertion and removal, large holes on the center column for good drainage, an elegant top.
There are two models to choose from.
Bathtub Drain Hair Catcher - No supports needed
Bathtub Drain Hair Catcher - Supports required.stl
One version does not require support material because it contains two sacrificial walls. After printing, simply remove the oval cut walls to reveal the drain. IMPORTANT: Make sure your silcer prints the two outside walls as a single layer of filament to make removal easy.
If you would prefer to add your own support material, you may instead print the second version.
Both models are printed upside-down to reduce support material and improve bed adhesion.
I recommend printing with PETG or ABS. PLA can be used but may degrade quickly and be harder to insert into the drain.
| Date published | 10/07/2020 |
| Support Free | YES |