Batmobile in Hot Wheels Scale
Batmobile in Hot Wheels Scale
3D
Published 2017-02-22T11:55:46+00:00
This little, Hot Wheels sized, batmobile runs nicely on its wheels with press-fit bearings (but it could do with some extra weight to really get up to speed - heating up a large nut and pressing it into the bottom will do the trick)
Front Wheels Bearings
Outer Diamter: 7mm
Inner Diameter: mm
Depth: 4mm
Rear Wheel Bearings
Outer Diamter: 10mm
Inner Diamter: 3mm
Depth: 4mm
(alternative option, use same bearing on front and rear - like these ones)
Screws
M3x8 Cap Screw (or similar length M3)
Supports are not strictly required, but might make for smoother wheel arches (and the overhang under the front fenders).
A layer height of 0.1mm will produce much better results than 0.2mm in this model, since there are many near-horizontal surfaces which show layer variations clearly.
| Date published | 22/02/2017 |
| Time to do | - 5 minutes |
| Material Quantity | 7.5m of 1.75mm filament |
| Dimensions | 85x25x35 |
| Technology | FDM |
| Support Free | YES |
Printed on a Fix in QQ-S delta printer