Recommended print settings with a .4 mm nozzle:
- Layer Hight: .150 ~.160 mm, depending on motors and gearing
- 2 perimeters or shells (0.90 ~0.96 mm)
- 6 bottom layers (0.9 ~ 0.96 mm)
- 6 top layers (0.9 ~ 0.96 mm)
- Infill ~20%, depending on infill type
Additional items needed for assembly in the model
- Medium CA or Epoxy
Please note that the parts are designed so that the frame is mounted from one side of the model first, then the box should slide in from the other side. In addition, the opening for the restraining strap should be facing the bottom of the aircraft.
1- Carefully cut an opening of appropriate size for the frame – Approximately 33mm X 133mm ( ~ 1 5/16" X 5 1/4"). Please double check the mesurement with the actual printed part, before cuting the opening.
2- Dry fit the frame in the opening that was cut in the previous step. Trim the opening as required to ensure that the frame fits in the opening. It should be a snug fit – Not a tight fit!
3- Once satisfied with the fit of the frame, remove it to apply your adhesive of choice and re-install to let the glue bond and set.
4- Apply glue to the box and install from the opposite side of the model. It may help to clamp the parts in place to let the glue set.