Hey, you know what. I got a Halloween Special Collection with 7 models for just $3.99 ONLY >>> Click here to see those models
Checkout my previous model of "Halloween Boo Cat & Pumpkin">> Cllck here to see it
This is my second version of my previous model & this time the Boo Cat is Trapped inside an Evil Pumpkin Jail. The model can be used also as an organizer. You can say its multi-purpose even after the Halloween fever is over. Its a cute little model that can be even printed big enough to place a real bird inside it & can be used as a Cage :D . If you dont wana trap a bird inside it, you can use it as a bird feeder or a planter. Maybe as a chocolate/Candy holder for your Halloween party. The uses can be endless , depending on what you want to use it for. If you do end up using it as a cage for a real bird, make sure to keep the cap glued to the body of the pumpkin , so that the bird does not escape :D
Print it at a layer height of 0.2mm, Orange PLA filament, 3 outer perimeters, 30% inFill, 4 bottom layers & 8 Top layers. Print time for a 100% scale will be approximately 15 hours.
You can enable supports everywhere on the model & it will be a piece of cake to remove them after the print. Removing supports is not even going to be an issue at all :)
Do tag me with your print photos on Instagram @tar1qali. You can also tweet me your print photos @3dguydubai.
Happy 3D Printing..!!