Campervan Grey Water Drain Spout
Campervan Grey Water Drain Spout
Published 2021-07-19T16:49:40+00:00
I created this spout as a better way of discharging grey water. It looks tidier and is better managment. It fits onto the grey water outlet that has the appearance of just a flap. These outlets are common on lots of smaller vans without a grey water tank. This makes it easy to have a bucket under the pipe and it certainly looks better.
Print with the retangular plate parallel and close to the print bed (looks a bit like a door handle attached to the bed). Choose supports touching the bed only (as opposed to everywhere). I printed mine in PLA on an Enders3.. I set fill to 15% but it's not critical. It takes a while to print (8rs depending upon printer and settings). I sliced mine in Cura which does a good job.
Date published | 19/07/2021 |