Fun! This printed very nicely with no support required. Thanks!

This is a fantastic design that printed perfectly. ColorFabb PLA/PHA Ultra Marine Blue 0.4 Nozzle 0.2 Layer height 2 Bottom layers 3 Top layers 2 Perimeters 50 mm/s

Printed well, looks great!

Great Print awesome design , painted nicely no trimming.

Très bon et rigolo, le même en bleu...

Wanhao D7 0.1mm with Monocure Black

Printed at 40% size on my Ultimaker 2+ Ext. with Colorfabb White PLA. No supports. Great little model!

Print in ABS Glow in the dark on my D-Bot

Standard settings in Cura, 0.175 layer height, 200 degrees on the extruder, 50 on the bed. Built-in BuildTak surface, and NO RAFT! 4 hours, 7 minutes to print, but it was so worth it!

print it in my prusa i3 and it's awesome

fantastic little print! thank you keep up the good work. Layer/H 0.15

200 °C print 60 °C Bed 0.1 mm layer

Painted in acrylics and finished with an assortment of static grass, pebbles and fluff. Write up with more photos can be found here: https://stuwahacreations.com/2018/03/01/3d-print-painting-part-7/

Black Verbatim PLA 0.3 layer height Tronxy x1

Thank you for an Awesome Model. Printed with CRON PLA, 0.3 Nozzle, 0.2 Layer height, 25% infill.

Printed at 32mm tall, with a 0.2mm nozzle and 0.1mm layer heights. Lovely model

Printed with inland PLA 0.2mm

Since everyone dogs on Makergeeks so much I decided to try printing this with some of the translucent red.

Acetone vaporsmoothed. Lost a bit of detail on the teeth. Pretty good model for painting practice. Still a lot to improve on!

Solutech translucent green pla temp 208 .6 nozzle

Printed in 0.2 Layerhight / 50mm/s / Fillamentum Vertigo Galaxy

Tevo Flash actually lol no selection avail! love your models!

This little guys DEFINITELY need supports everywhere! With the default support settings in Cura, they are simple enough to remove and leave almost no surface blemishes. Just be sure to set the [Support Z Distance] to the layer height you are using. In my case, 0.1mm. Straight off the printer, he looks great, but to make him pop, I decided to give him a few painted elements. Painted with Plaid's Multi-Surface Acrylic paints, I think he looks amazing.

Printed on MakerBot 2. @ .15mm

My legion of downsized chibi reapers to send after my players in our D&D campaign.

Printed in 0.2mm, at 60mm/s with some cheap glow in the dark filament and I think he turned out great! I'm still very new to 3D printing and this was my 5 successful print with the Ender 3 (we don't talk about the failed kitty cats while tuning). Came out better than I expected and can't wait to see him glow in the dark. I think I need to go bigger with more infill than the usual 20% from some of the reviews I read about the filament. Going to see if I can get it painted and leave just his face on show. Great model!!

Lovely Little Death-figure