This is my first Christmas ornament design. I put some time and efforts into this project but decided to share it with everyone as free since this is my first Chritmas upload.
it has a slot for a small photo which you will need some support. I have not tried yet, but it may work ok with no support if you have a good setting. I'll try and update soon. If you are using cura or slicer, set the support as 'everywhere' and it should set up the supports only in the picture slot area. Peeling off the support has been pretty easy with small nose-plier .
I've made over 20 of them, and more to go, but the model has been printing very nicely... not a single fail yet.
My recommandation is to print it in neutral color filament and just color the raised out-lines with sharpies (as shown in my pohtos). But you are the builder of your own snowman, so go ahead be crazy and have fun printing :)
I wish everyone a very merry Christmas!