Measures around 33 1/2 inches in length. Takes about 2 and 1/2 2.2 lbs rolls of filament to print.
Features provisions for working Trigger, reload slide, ammo clip and removable can/batteries.
It's designed to be assembled into a few sections Handle(Orange), Bottom (teal), Body (Purple), Top (White) and Rail (Blue). The Top and Bottom sections are designed to have a 1/2 dowel,pipe inserted for support. The Body section is designed to take a 3/4 inch dowel/pipe for support.
Assembly process advice:
Step 1: Assemble the individual parts into sections.
(Blue) Top and Bottom Rails:
Top Rail 1, Top Rail 2 & Rail Top. Then Bottom Rail 1, Bottom Rail 2, & Rail Bottom.
(Red) Little Cylinder:
Little Cylinder, Little Cylinder Detail, & Little Cylinder Braces.
(White) Top Body:
Top 1, Top 2, Top 3, & Sight. Insert a 1/2 dowel in now, remember to leave enough length out so it can slip inside the Top Rail section.
(Teal) Bottom Body:
Bottom 1, Bottom 2, & Bottom 3. Insert 1/2 Dowel in at this point, make sure to leave enough length so it can slip inside the Bottom Rail too.
(Green) Big Cylinder:
Big Cylinder, Big Cylinder Front, & Big Cylinder Detail.
(Yellow) Hose Housing. Leave Hose housing L and R separate for now.
Body 1, Body 2, Body 3, Body 4, Body 5L, & Body 5R.
Handle 1L, Handle 1R, Handle 2L, Handle 2R, & Trigger.
Step 2: With all sections assembled you should take the Handle (Orange) section and attach it to the Bottom (Teal) section. This makes the Full bottom section
Step 3: Attach Top (White) section and Full Bottom section (Teal and Orange) to the main Body (Purple section.
Step 4: Slide the Big Cylinder (Green) section and the Hose Housing (Yellow sections in from the sides. Insert your 3/4 dowel in afterwards, remember to leave enough length so the Little Cylinder part can slip on it too.
Step 5: Slide the Little Cylinder (Red) section from the front.
Step 6: attach the Top and Bottom Rail (Blue) sections onto the 1/2 dowels and to the Top (white) and Bottom (Teal) sections.
Step 7: Attach the Hose Rings to the Body, the Hoses, the Reload section and that should about have it. The cans/batteries go as follows, 2 slide into the top of the main body and the third one goes inside the Ammo Clip. For the two to the main Body I'd recommend using magnets to hold them in place.
The Hoses have been scaled to 1/2 so you can either print them or substitute them for real 1/2 hose. (The pictures above are with printed Hoses)
Outside of the order in which the sections must be attached I didn't have to do much else specific.
Any questions feel free to ask, thanks!
I'm over on Facebook if you want to catch progress updates and stuff. facebook.com/ChronosCreations
Better Devil's is next on my posting list.
I kindly ask that you do not print to sell this (especially without my permission). I made this model for people to enjoy, not profit off the hard work I put into this. Thank you