COVID Cookie Cutter
COVID Cookie Cutter
Published 2020-11-24T11:25:15+00:00
Make COVID-Cookies for the worst Christmas ever - 2020 hooray!
Check my profile for other Corona-related Cookie Cutters :)
There are four parts:
1. The actual cutter for the virus-outline
2. A stamp for adding the circles
3. A handle for the stamp
4. The extractor for pushing out the cookie/lifting the cutter without breaking the stems
The little stems tend to break off when trying to move the cut cookie onto the baking plate so its best to roll out the dough on a baking sheet already on the plate, cut, stamp and extract the cookies in place and just remove the excess dough.
Instructions: Dip all the parts in flour to make them less sticky. Insert the handle into the slot in the back of the stamp and twist it to lock it in place. Cut the cookie, then stamp it with the outline cutter still in place. Don't stamp it too deep. Remove the stamp, insert the extractor. Lift the cutter while holding the cookie down with the extractor.
PLA works just fine
printed in 0.3mm layer height with 3 solid top/bottom-layers
Dont put PLA prints in the dishwasher!
Date published | 24/11/2020 |
Support Free | YES |