CREALITY CR10S FRAME BRACKET (15X15 ALUMINUM BARS)
CREALITY CR10S FRAME BRACKET (15X15 ALUMINUM BARS)
3D
Published 2018-12-14T09:12:09+00:00
Frame brackets for creality cr10s to use with 15x15 mm aluminum bars.
I did it to make the frame stiffer, reduce vibrations at higher part of the gantry that might affect taller prints.
Top part has a high clearance that i needed for my e3d v6 hotend upgrade.
Holes are 6mm diameter and i used M5 bolts and nuts and t nuts.
I used M5x12mm and M5x30mm and washers to spread the load around the holes.
15x15 bars are under 60cm long (i think 59cm should work) but first fit the brackets and then put in the bar and mark it for cutting and drilling.
Tolerances are tight and make sure that your printer is leveled.
Print it with flat surface placed on the bed.
0.2 layer height
3+ perimiters and top bottom layers
20+ % infill
no supports needed
Larger flat surfaces placed on the bed
| Date published | 14/12/2018 |
| Material Quantity | approx 100 grams |
| Support Free | YES |