Curved LED Strip Lamp
Curved LED Strip Lamp
Published 2021-01-06T10:51:58+00:00
Curved and skinny brother of https://www.myminifactory.com/object/3d-print-148013
It's a risky one. Print if your printed is well calibrated since dovetails on this one does not have much tolerance for fit.Adding their photo side by side for comparison.
A dab of super glue or generic clear glue like UHU in the tails would be helpful.
It can accommodate longer strip than other model mentioned above: 60 vs 50cm
Center of mass was calculated to be on the stand center. It doesn't have magnet slots under the stand unlike the other version.
Printing tips:
Since it's long and skinny, I recommend dropping anti-warping brims to the ends
https://www.youtube.com/watch?v=D45eIhoWSyg
Stand should be printed sideways for stronger mounting point for the post. It will require support anyways.
Date published | 06/01/2021 |