Cn Info
Yond東玖 | 原创模型 | CC BY-NC-ND
-----------------------------------------------------------------------
特别设计用于放置头戴式耳机，赛博风格+独特的夹持设计+优化过的“低耗材高强度”结构

-----------------------------------------------------------------------
可夹持的桌面厚度为34mm以内，占用桌板边缘下方35mm宽度，耳机槽底宽约40mm（耳机头梁宽＜45mm）；
本体建议0.2-0.3mm层厚打印（建议增加裙边防止打印翘边），其余零件建议0.1-0.15mm层厚打印；
具体强度跟您使用的材料、壁厚、内填充有关，请根据需求自行调整。

具体信息参见视频内容↓
理工男美学的5个3D打印小制作↓
https://www.bilibili.com/video/BV1nb4y197yi

--------------------------------------------------------------------
▲警告▲
本设计经历了N次设计迭代修改，创作不易，感谢支持和打赏~
版权归B站Yond東玖所有，模型仅供大家学习和非商业性自用~

En Info
Yond東玖 | Original Creation | CC BY-NC-ND
--------------------------------------------------------------------
This is specially created for your headsets with cyberpunk style design and unique clamp structure design, optimized with little material usage as possible while maintain high strength performance.
--------------------------------------------------------------------
The table board with thickness under 34 mm is applicable. This holder will occupy 35 mm wide space below the edge of the table;
The width of the headphone slot is about 40mm (the headphone beam width should be less than 45 mm);
The frame is suggested to be printed with 0.2-0.3mm layer thickness（enabling skirt is suggested to prevent warping）, and the other parts would be good with 0.1-0.15mm layer thickness;
Strength depends on the material you use, wall thickness, infill style and percentage, please adjust according to your demand.

See video bellow for details↓
理工男美学的5个3D打印小制作↓
https://www.bilibili.com/video/BV1nb4y197yi
--------------------------------------------------------------------
▲warning▲
This design has undergone I don’t know how many iterations, it is not easy to create. If you like it, plz press that heart icon~ Tip me if you love it and thank you VM for your appreciation!
The copyright is owned by Yond東玖, the model shared is only for study purpose and non-commercial personal use.