Shell for DC 775 motor (perfect fit)& Speed controller shell.
-Small base (Scale to 1000%, I'll fix it later).
Motor center have a 3.5cm height without the base, 4.5cm height with the base.
Use small base if you're not using rail or track.
Motor height can be adjusted by adding some nuts over the base.
Base contains screw holes with 4, 6, 8 and 10cm wide if you need to put on a rail.
Screws needed for Motor and Power:
4 M3*35 screws for the motor shell.
4 M3*20 screws for the controller shell.
4 M3*30 screws to hold the controller on the motor (if needed).
4 M2*6 screws to hold electronics inside the controller.
2 M4*8 screws for the motor front side.
Screws needed for Base (if on a rail).
4 M3 or 4 M6.
**Choose screw length according to the rail thickness.
Better to print with 3 layers on the top, bottom and 4 wall sides, with 30% infill.