Death Archon Proxy
Death Archon Proxy
3D
Published 2020-11-27T09:51:26+00:00
After seeing the new model for the Death Archon in Warmachine/Hordes, I thought it looked familiar. I looked up the Reaper Form of Death from Darksiders 2, and decided it was close enough. It took me hours of searching, but I finally found a 3D model of it here:https://assetsdownload.com/free-skeleton-death-with-scythe-3d-model/
Anyway, the model is so close that I barely had to change it. I did add some stuff though. I used this skull for the belt:https://www.thingiverse.com/thing:1040192, these ribs for the ribs:https://www.thingiverse.com/thing:4331732, and the wing bits from this model cause I couldn't figure out a good way to do it:https://www.thingiverse.com/thing:4391098. Unfortunately, every time I tried to run it through Netfabb, it would fail to load the mesh, and running it through other fixing programs failed to rectify it, so I'm just uploading it as is, but that means somethings wrong with it somewhere. I put it on a 50mm base that I made a while ago in Inventor, and added a hole for a magnet.
After printing it once, I found that the wing tips were too pointy to connect to the supports, so I had to thickened them.
I printed this on an elegoo mars.
I'm not sure why the wings don't show up in the preview, but they are there when you download it.
| Date published | 27/11/2020 |