Drill bit stand
Drill bit stand
Published 2019-08-26T00:00:12+00:00
I bought a Chinese drill set. Looking through various stands, I noticed that the biggest problem is the clear marking of the drill diameters.
Since almost every printer allows you to use the filament change function, you can make this stand with a single head.
Material: PLA+
Rafts: no
Support: no
Speed: 60mm/s
Infill: 10%
I printed the stand with a standard 0.4mm nozzle.
Drill size labels were made with a 0.2mm nozzle and 0.15mm layer height.
I used the Cura slicer and the "Change filament" script.
Because after changing the filament in the nozzle 0.2mm there is excess material left, I used the "0" sign, which allows you to get rid of excess filament. You must set it closer to the zero position of the table than the rest of the printout. Thanks to this, Cura will start printing from this element.
I did many different attempts, only adding waste sign did all the dirty work.
Date published | 26/08/2019 |
Support Free | YES |