Eyepiece Cap
Eyepiece Cap
Published 2018-07-09T16:57:17+00:00
This object was made in Tinkercad. https://www.tinkercad.com/things/aNSdqqP6vQk
Nothing Special. Tube OD in Tinkercad was 31.75mm and printed at about 31.75 and fit perfect off the printer without post processing. Adjust for your known printer tolerances.
Im using a lightly modified Anet A8 with a flow rate of 99%. 200 Deg hotend and 80 deg heated bed. Cooling off until layer 3 then 50% unitl layer 5 then 100%, Played with thins until I achieved the best bed adhesion without curling. But still fairly new to 3D printing and learning as I go.
Pxmalion White PLA (prints perfect every time and not issues at all with the entire roll)
.4 Nozzle
.3 Layer
Shell:
- 2 sides
- 3 top and Bottom
10% infill
Date published | 09/07/2018 |
Technology | FDM |
Complexity | Easy |