Please enter the code below
This lets you mount your Fairphone 3 (FP3) in your car snapping onto an existing car mount. There are two versions, depending on if you intend to use the rear facing camera or not.
Snap onto the existing mount with care. If tolerances are too tight, use a needle file where necessary. Check regularly to not introduce too much slack.
For improved layer adhesion, print with 0.15 mm layer height and 0.6 mm line width on a 0.4 mm nozzle. Make sure to choose material that can withstand the temperatures in your car, your standard PLA will start deforming at or even below 60°C.