Check out our Etsy here: https://www.etsy.com/shop/3DCentral
It wouldn't be an adventure without a sword made of Demon's Blood!
Note: sword is likely not adventure ready; if you strike just about anything with it, it is likely the sword will break before whatever you are slashing at. But it makes for an awesome costume piece!
Print out one of each, except for 'pin 2' which you will need 6 total.
Assembly is then pretty straight forward, snap pieces together with pins. The hilt is probably the trickiest print because of it's size, but just about all of them require the bed to be very well leveled.
The final sword might be kind of wobbly --- if you apply a liberal amount of super glue to each pinpeg as you assemble, the final product will be a lot more sturdy.
Pin Connectors V2 by tbuser
This file has been released under the Creative Commons - Attribution - Share Alike license.
Finn's Demon Blood sword from Adventure Time by CarryTheWhat
Originally Published on August 1, 2013
Creative Commons - Attribution - Share Alike