Fossil Watch Wall Mounted Charging Stand
Fossil Watch Wall Mounted Charging Stand
3D
Published 2020-05-29T11:31:51+00:00
This wall-mounted charging stand allows you to charge and keep your Fossil Smartwatch out of the way, while still being easy to access.
Included is a Fusion 360 file. There, you can adjust these parameters:
The dimensions of the screw hole to fit whatever screws you're using
The offset of the dovetail joint. The default is what worked for me at a .28mm layer height, yours will likely be smaller.
If you like this model, please feel free to support me at
https://www.buymeacoffee.com/JoshuaA
Installation instructions (coincides with pictures)
- Screw the wallplate into the wall first, and make sure the holes are aligned.
-Back out the screw a little bit on one side, and all the way on the other side, so you're able to slide the charger cable into the groove on the back. Partially screw back in the screw that was fully unscrewed
-Clip in the charger holder into the dovetail joint.
-Put the charger itself into the space in the charger holder, then pull the remaining cable from the bottom until all of the cables nestle nicely in the grooves.
-Finally, screw back in both screws all the way so the wall mount is flush against the wall.
| Date published | 29/05/2020 |
| Material Quantity | 15 grams |
| Dimensions | 42mm x 52mm x 49mm |
| Support Free | YES |