Filament brand: Enotepad
Filament color: Silk Rainbow
Filament material: PLA, but PETG preferred
In order to deal with the stress the driver will create and to sound as it should, print with:
40% to 50% infill. I used 40% cubic.
PETG or PLA but PETG preferred due to it's strength and better ability to take stress.
If you can, slow down the cooling fan a little to make sure the filament bonds very well. If using PETG as I did, turn off the cooling fan. Another option is to extrude at a slightly higher temperature.
Note that all three files need to be printed. The 1st is the speaker cabinet and the second is the speaker stand and the third is the bezel.
2 RS100-4 drivers
1 set Binding Post Banana Jack Pair Extra Long Shaft
1 Acousta-Stuf Polyfill 1 lb. Bag Speaker Cabinet Sound Damping Material, you will use much less than 1 lb
2 Parts Express Cast Frame #8-32 Speaker Mounting Kit
To connect the binding posts to the driver:
Crimp on connectors or
Soldering iron and solder