GoPro 5/6/7/8 Dummy for FPV drones
GoPro 5/6/7/8 Dummy for FPV drones
Published 2021-07-05T09:58:06+00:00
This is a dummy for a GoPro 5/6/7/8 to be used in the mount of an actual GoPro on an FPV drone. The purpose is to not risk the GoPro when not filming (e.g. tuning, practicing) withought compromising the flight characteristics of your drone. After printing, screw in four (4) M12-L30 or two (2) M12-L60 set screws that will increase the weight of the dummy in order to reach the GoPro's weight.
Prior to printing this, weight your set screws and then adjust the weight of the print on your Slicer SW by changing the infill so that the final dummy will have the same weight as your GoPro.
E.g. for a GoPro Hero 7 black that weights around 116 gr: if your set screws weight 75 gr, you should adjust your infill so that the print will weight 41 gr.
Finally, print with AT LEAST a wall count of 3.
Date published | 05/07/2021 |
Support Free | YES |