Hex Drawer with visible contents and name slot
Hex Drawer with visible contents and name slot
Published 2021-08-04T07:37:19+00:00 • Remixed from Hex Storage Drawers Dovetail
This is a remix of the poplar dovetail hex-drawer design that was first remixed by LegionOfTheRepublic.
My modification allows you to see what is inside the drawer. and I've also added a small slot at the front to add a little card to say what is in the drawer.
I use these for organizing all of my fasterners, and being able to see at a glance if I'm running low of anything I find super helpful. Also being able to check whether I've grabed an M3, or M4 nut can be super helpful if you're not paying attention
I found the drawers a little difficult to fit into the existing design files so I recomend printing at 95% of full size to let them slide in and out easily.
No support needed
I print at the lowest quality possible and it takes a little over two hours to finish.
I recommend printing with a raft, but it's not explicitely needed for them
Date published | 04/08/2021 |
Time to do | 150 - minutes |
Support Free | YES |