Ice Cream Cone - Just like a regular cone but reusable!
Ice Cream Cone - Just like a regular cone but reusable!
3D
Published 2017-03-20T12:30:02+00:00
If you like eating ice cream from a cone but don't like soggy cone at the end and resulting mess this could be your solution.
Designed to regular ice cream cone size, this cone lets you add scoops as with any regular cone. It has a flat base surface approx. 20mm / 1 inch below the top rim to retain the ice cream at an easy to get to level. .
Enjoy the ice cream as usual on this 3D printed serving dish.
Not sure how well PLA does with dishwashers so hand washing suggested.
Prints well on a Replicator 2 with 4 shells and 35% fill, use raft but no support as the required support is designed in. It should pull away easily from inside the rim.... then go enjoy a couple of scoops of your favourite ice cream.
| Date published | 20/03/2017 |
| Technology | FDM |
