Please enter the code below
In honor of the polar vortex an Ice Scraper modeled after those promotional ones the banks used to give away.
This object was made in Tinkercad. https://www.tinkercad.com/things/9q3V2zNTBPX
the one in the picture was printed at a .28mm layer height with 20% in-fill.
I wouldnt print any lower in-fill % to ensure proper rigidty and structural integrity.
Printed the top with an extra layer (4) because of the intended wear and tare.
Accidently printed with a brim (unneeded) in the photo, but a skirt is recomended