iSpindel holder and calibration base
iSpindel holder and calibration base
3D
Published 2020-11-11T15:38:35+00:00
This design is solving a small problem I had when servicing and charging my iSpindel devices. They were more than often laying on the bed or desk, moving aorund etc. I decided I could fix this, so this base was born. It fits the large Petling around 50mm diameter and holds it straight up. Also the base works as a small stand to calibrate the 90 degrees or zeroing the device. I tried to make it modular so that pieces snap together when having more than 1, it does work but i would need to work on thos snap fittings more, for the time being i would use just glue on those sides.
Leave a comment and any feedback if you wish, it would be greatly appreciated.
Cheers! Happy Printing and Brewing!
I used support enforcers for the snap fitting, it adds very little material and time to the print. Used 0.3 layer height in PLA and looks and works pretty well, no real need to have high definition here.
| Date published | 11/11/2020 |
| Time to do | 120 - minutes |
| Material Quantity | 40g |
| Dimensions | 57x42x105 mm |
