Joycon Grip Holder
Joycon Grip Holder
Published 2020-08-11T14:54:47+00:00
This is a Nintendo Switch Joycon Grip Holder. This is designed to hold two standard or charging Joycon Grips with the Joycons on them.
I had my original Joycon Grip always laying around while the Joycons were on my Switch. I also had a charging grip and an extra set of Joycons that found themselves on desks or floors more often than not. This stand just gives me a place to put the grips when I'm not using them.
The stand pictured is my custom version that doesn't let you place the upper grip in with joycons attached. This is so I can't be lazy and not hook the Joycons to my Switch to recharge them when I am done. The actual model will let you be lazy.
I printed with no supports, .2mm layer height, 5 walls all around, 10% infill, and 100mm/s on a modified Ender 3.
This could easily be done with higher layer height, less shells/walls/top-bottomlayers, and 5% infill.
Very simple print.
Date published | 11/08/2020 |
Time to do | - 480 minutes |
Material Quantity | ~102 grams |
Dimensions | 50mm x 100mm x 95mm |
Support Free | YES |