painted to look like stone

0.4 mm Nozzle 0.3 Layer Height 3 Perimeter Lines 5 hours to print Printed upside down I would like to take part in MyMiniFactory Wonderland

Printed with Formlabs grey resin at 100 microns.

the only problem is my face too fat.......

haha

Scale it up 15% to fit my face. Printed and finished this to go with my cyberpunk street samurai gear! Love the design!

Printed at 150micron, AprintaPro silver pla. After that, 3 layers of XTC3D, some layers of spray filler and priming later, i have a smooth surface for painting. I also closed the holes, because i am going to add a better mount.

My first attempts at doing masks - the scaling is an issue but happy with howthey turned out.. One for me, one for my son. Printed with RigidInk grey PLA. Quite a nit of support needed underneath and for the teeth.. Airbrushed using an Iwata CN and Vallejo Air paints. Another good airbrush practice session..

I love it. I underestimated the size of my face.

Un diseño muy genial, ahora voy a imprimir una del tamaño de mi cara :D

my anti-covid mask

Battleworn - red bronze

Fresh off the printer! The print turned out great...

Mask of the Murderous Geisha ... Passed on through the centuries, each owner repainted the mask in hopes of hiding the bloody fangs ... and her crimes!