LED Strip Lamp for 50CM strip. You can find one of these on Aliexpress for 2-3 dollars. Just pull it through the base hole, then remove 3M double sided tape on the strip and paste it on the surface. You could probably paste two side by side if desired, depending on width of your strip.
Split into 3 pieces with dovetail joints for ease of printing. Bottom has two holes, I fastened some round neodymium magnets into them so this won't fall off my cubic printer's frame. I'm using it for monitoring my prints.
Supports required only for base. Print the others in sideways orientation. Might be worth a while to drop couple of coin size brims to dovetail parts as they can peel off the bed and warp since this will be a large print.
Follow @sdkks65 on Instagram for the videos