Printable Bits for upgrading a Monolith for use of LEDs.

- The crystal has a hole for a 5mm LED on the bottom. I printed it in Glass PET-G with 0% Infill, 5 bottom- and top layers, and 3 walls. No support required.

- The portal consists of two pieces - the holder, and the event horizon. The holder has a hole for a 5mm LED on one side, on the other side comes the portal. after fitting the LED, I'd put something for diffusing the light on it. I used translucent silicone, as seen in the picture. Again for the portal, I used Glass PET-G. this time with 100% Infill, for not creating holes inside it