So this is my first upload, any problems let me know.
The frame shown in the images was of a specific sized lithophane however I've included three different sizes in the set for you.
100mm x 100mm
150mm x 150mm
200mm x 200mm
I've also allowed for all lithophanes to be a width of upto 3.5mm and have a 3mm border. If you use the 3dprocks website like I do, this 3mm border I believe is included in the for example 100mm diameter.
I've not had a chance to test these all out yet so if there are any issues then be sure to let me know.
As you can see it requires a tiny bit of work. I taped the back with adhesive reflective tape you should be able to pick up from any hardware store. The LED's I simply cut down to size, just be sure to leave space so you can open and close the lid, I left a good 15mm for this.
I think thats everything, enjoy and share your own photos of final printed frames. I created this with the intention of making a small collage.
P.S. The picture shown, I do not own. It is purely for showcasing, the rights belong to Sierhaus at SuicideGirls.