Temporarily moved to work in progress. This will still work for prints that use up to 75% of the build height, but currently the filament tube anchor is too close to the extruder when printing at full height.
This design was made with onshape [here](https://cad.onshape.com/documents/376d91ffe88aeacc916390e2/w/4f3c286364331b1dd0205ef2/e/e9395b1c80432317548ebac0).
- two m3 screws to fully anchor on the rail
(Note completely usable without the screws)
# Change Log
- 2018/01/31 Updated the angle that the tube is mounted so that it does not bend too much for taller prints