This is my entry for the Nintendo Switch Design Challenge. This is a model of the Lynel monster from The Legend of Zelda: Breath of the Wild acting as a stand for the nintendo switch. With it's swift and intelligent movements, the Lynel is by far my favorite monster in the series.
I made this stand for a desktop setting, such as in an office or at home. Under the base is a slot and hole for a charger cable to fit through. The base also acts as a multi cartridge holder.
This was 100% sculpted by me. I did not use any in-game models to create this model.
Infill isn't necessary, but recommended for further stability. I printed this in parts, using lower end settings on an M3D printer. It took at least 24 hours to print.
If you like this model, make sure to check out my other models on my page as well!