Magpie Pin from the Magpies Pod
Magpie Pin from the Magpies Pod
3D
Published 2019-07-25T13:53:07+00:00
I am a huge fan of the Magpies Real-Play Podcast, and in the show, when the team completes a job, they leave behind a small pin with a Magpie on it.
The ide took form in my mind and using some pictures of Magpies in flight, I designed this model.
This is the first iteration and may improve over time.
Check out the Magpies podcast here: http://magpiespodcast.net/
This model is made for the Magpies and they own the sole rights to sell this model. This model is put here under creative commons (Non Commercial) by their consent.
Printed on a DLP printer at 0.05mm layer height. You could go lower and reduce the layer lines but I think they add some detail that this currently missing.
If you are printing on a Photon or Mars then print flat, at 85% to keep it small.
| Date published | 25/07/2019 |
| Time to do | 20 - minutes |
