Montini building bricks Two Pip Set (Lego Compatible)
Montini building bricks Two Pip Set (Lego Compatible)
3D
Published 2020-01-10T18:29:36+00:00
Montini building bricks were produced from 1961 to 1969 in the Netherlands. They were originally made from soft, pliable polypropylene. The diagonal fins bend slightly around the pips of the other block.
http://www.puppenhausmuseum.de/montini-bausteine.html
Files with "_RED_" in the filename have fins with the opposite direction. Most white bricks go the "normal" direction, and most Red bricks go the other direction. Mixing both directions in your creations will give a tighter fit.
Just like the vintage original Montini parts, these are compatible with classic Lego full height bricks.
Please do not mix these with original Montini parts. PLA is much harder than the original bricks, and the layer ridges act like sand paper. You will wear out the original Montini bricks very quickly.
I have modeled most of the original Montini parts. I will upload the rest in the near future.
These are optimized for a 0.4mm nozzle. They are friction fit parts, so tolerances are important.
Before printing, check that the infill angle is across the diagonal fins. That will prevent sagging of the first layer of the top plate that has the pips.
| Date published | 10/01/2020 |
| Support Free | YES |