Montini Lion Wall Set (Lego Compatible)
Montini Lion Wall Set (Lego Compatible)
3D
Published 2020-03-06T20:55:12+00:00 • Remixed from Relief with a lion, Montini building bricks Pip Strip Set (Lego Compatible), Montini building bricks Two Pip Set (Lego Compatible), Montini building bricks Female Plate Set (Lego Compatible), Montini Building Bricks Roof Pieces (Lego Compatible), Montini building bricks One Pip Set (Lego Compatible)
This set of Montini bricks forms a relief showing a winged lion holding a symbol, accompanied by two characters in the left corner. This piece could have possibly been a symbol for a city, showing the lion as a guardian and protector of sorts.
Just like the vintage original Montini parts, these are compatible with classic Lego full height bricks.
Montini building bricks were produced from 1961 to 1969 in the Netherlands. They were originally made from soft, pliable polypropylene. The diagonal fins bend slightly around the pips of the other block.
puppenhausmuseum.de/montini-bausteine.html
Please do not mix these with original Montini parts. PLA is much harder than the original bricks, and the layer ridges act like sand paper. You will wear out the original Montini bricks very quickly.
I would love to see your make!
Original art scan by Scan The World:
www.myminifactory.com/object/3d-print-relief-with-a-lion-94743
Rafts:No
Supports:Yes
Resolution:.15
Notes:
These are optimized for a 0.4mm nozzle. They are friction fit parts, so tolerances are important.
I set the Horizontal Shells Top to 7, and Bottom to 10 to allow for the relief to have infill, but the brick to be solid.
The following parts need supports on the relief section. The bricks themselves do not need supports:
0_2_ReliefWithALion.stl
0_5_ReliefWithALion.stl
0_8_ReliefWithALion.stl
0_9_ReliefWithALion.stl
1_5_ReliefWithALion.stl
1_6_ReliefWithALion.stl
1_8_ReliefWithALion.stl
1_9_ReliefWithALion.stl
2_0_ReliefWithALion.stl
2_6_ReliefWithALion.stl
2_8_ReliefWithALion.stl
2_9_ReliefWithALion.stl
3_2_ReliefWithALion.stl
3_8_ReliefWithALion.stl
3_9_ReliefWithALion.stl
4_8_ReliefWithALion.stl
| Date published | 06/03/2020 |