Multi-Level Support for OpenForge dungeons
Multi-Level Support for OpenForge dungeons
Published 2015-06-19T15:36:22+00:00
OpenForge and DwarvenForge are awesome, but what if you want to make a multi-level dungeon?
This cylinder is exactly the right height to stack OpenForge and DwarvenForge tiles on. Each cylinder also features 4 tabs at the bottom. Print the included clip file and slide it over the tabs to hold the cylinders together. I designed the clips and tabs to fit a little loosely, so you have some play when trying to align several cylinders at once.
The cylinder is about 2"/5cm high and 1.4"/36mm wide not counting the clips; with the clips it's 1.8"/46mm wide. The clips are 0.36"/9mm by 0.27"/7mm by 0.43"/11mm.
Both pieces print without support or raft.
Thanks to my Patreon supporters for their pledges, which made these pieces possible.
Print at 0.2 mm layer height, with 10% infill. This uses 14 g of filament and takes 1 hour and 11 minutes.
Date published | 19/06/2015 |
Material Quantity | 14 |
Dimensions | 50 x 48 x 50 mm |
Complexity | Easy |