Nintendo switch lite dock stand
Nintendo switch lite dock stand
Published 2021-06-21T08:44:24+00:00
This is an extension to the switch lite dock that I made (you can find that on my profile). After printing the switch dock, I realised I had miss calculated my cable so instead of printing it all again and wasting filament, I decided to make this. It has a cut-out to allow a cable to be routed through the back and into a plug, it also has storage for up to 16 games. What I have done is after this had finished printing, I cleaned it up and stuck it to the bottom of the switch lite dock using super glue. I did that because it needs a good firm bond to be able to safely hold the switch lite without chance of it falling over.
The more infill you choose to use the heavier it will be and therefore it will act as a weight to hold it in place. I chose to use 25% infill because I wanted it to print quicker however, when I have some more black filament, I will be reprinting this in black with a higher infill for the final product.
Any questions feel free to ask.
With 25% infil and 3 bottom and 3 top layer with 2 perimeters it took about 4 hours to print.
Date published | 21/06/2021 |
Technology | FDM |
Support Free | YES |