Nixon The Mission charger stand
Nixon The Mission charger stand
Published 2020-07-09T13:16:31+00:00
This is a replacement stand/charger for Nixon the Mission smart watch as is hard/impossible to get a new charger for this devices (the company discontinued the product).
I consider this charger a little better than the original, as it support all the base of the watch. The original seem to tilt the watch and depends on the magnets alone to mantain a good contact.
Besides the 3d print you need:
- USB breakout board, im using "U3-206 SMT Type USB-C Female Socket Breakout Board " but you can use any board that you consider, or even adapt a cable to the pins.
- Magnets, i'm using 2 5.5mm magnets salvaged from damaged headphones.
- Pogo pins, i'm using 2mm Dia 6mm Height
On the picture, top is negative, bottom pin is positive. A little soldering and glue and you should be finish with this charger stand.
Date published | 09/07/2020 |
Support Free | YES |