Phone Seat
Phone Seat
Published 2020-05-04T19:20:00+00:00
This is a variation on my previous design that proved to be a little unstable with larger phones. I took inspiration from my in-car holder and put the side grips on. I am always catching my phone and knocking it of sideways so hopefully this will solve that problem.
The sides are geared so that they pull out together, just make sure when you glue them in place you get them straight, unlike me.
It’s pretty straight forward how to put it together, but if you have any problems let me know and I will try to help.
I did use supports and a brim, unfortunately I had a few problems with the base. Nothing to do with the model I have a bad batch of filament that continually clogs my printer nozzle. Because of this I split the base into 2 parts: - base and stem. This was to save on the little good filament that I had after 4 failed attempts. For some reason my slicer would not attach a brim to the bottom of the stem, so a attached my own.
Date published | 04/05/2020 |
Support Free | YES |