Picatinny Mounted 2x AAA Battery Holder
$5.00 Picatinny Mounted 2x AAA Battery Holder
3D
Published 2021-08-18T16:45:15+00:00
A simple 2x AAA battery holder clamp that attaches to standard picatinny/weaver rails. Held in pretty secure.
Push bottom (negative terminal) of battery into bottom 'cup', then apply pressure to positive terminal to click into place unter the tab notch. Remove by opposite process--pulling positive end out first, then sliding out of negative terminal 'cup'.
Secure into place on the rail with a standard 6-32 machine screw & nut
Good for airsoft, paintball, milsim, or any actual real-steel use for stuff like target practice or hunting.
(Note: Model photos are pictured on a King Arms P90 Airsoft setup)
Best printing setup is as oriented in the file, for best layer line structural integrity; but if you can't get the supports to work effectively, lay flat with the battery holder facing up (as shown in the photos). It's easier to print that way but not as strong. Print in at least 25% infill with thick walls; PLA should be fine for light duty use, but you'll probably want something tougher if you plan on abusing it
Best printing setup is as oriented in the file, for best layer line structural integrity; but if you can't get the supports to work effectively, lay flat with the battery holder facing up (as shown in the photos). It's easier to print that way but not as strong. Print in at least 25% infill with thick walls; PLA should be fine for light duty use, but you'll probably want something tougher if you plan on abusing it
| Date published | 18/08/2021 |
| Price | $5.00 |
| Dimensions | 5.1cm (length) x 3.1cm (width) x 2.7cm (height) |