Plague Doctor Mask - Flat edges for easier printing
Plague Doctor Mask - Flat edges for easier printing
3D
Published 2020-04-05T03:05:12+00:00 • Remixed from plague mask- Full Scale
This is a very slightly altered design of the plague mask released by Alan Stanford : https://www.myminifactory.com/object/3d-print-plague-mask-2721
All I did was flatten the vertices along the bottom of the mask so that when printing the mask sits on the print bed better. Even when attempting to auto-orient the bottom, the slight curve of the pieces caused small print issues and adhesion issues on the first layer.
I've printed this in Repetier-Host using a Printrbot Simple Metal with extended X and Z axis and an Ubis13 hotend.
0.3mm layer height, no support, 60mm/sec print speed, 20% infill.
| Date published | 05/04/2020 |
| Time to do | 75 - 76 minutes |
| Support Free | YES |
Resized a bit, because printer bed wasn't big enough. Printed on a Tronxy x1 (not listed) 150x150 bed