Prusa Car Ornament
Prusa Car Ornament
Published 2021-01-06T13:54:05+00:00
Want to show off your 3d printing hobby to your neighbors?
What better way than decorating your car with this ornament!
The included model is a 5 by 11cm car ornament with the text "My other car is a Prusa".
If you'd like the ornament to be larger, you can scale the model in the X and Y dimensions in the slicer.
Hooks
The hooks are designed to fit suction cups with an 8mm "slot", but you can also use suction cups with hooks if preferred.
Multi-Color Printing
The model can be sliced to achieve a multi-color print, as pictured.
Configure your slicer to pause the print the following heights to allow you to swap the color of the filament:
- 1mm (load the color for "My other car is a")
- 1.6mm (load the color for "PRUSA")
If you scale the model in the Z dimension, keep in mind that you need to adjust the pauses for reloading the filament as well.
NOTE: If you are slicing with PrusaSlicer, you'll need to insert the pauses *after* the noted heights, so at 1.2mm and 1.8mm respectively for it to print correctly.
I recommend printing with a layer height of 0.2mm which is both good quality, and quite fast, since the model is small (should take about 40 minutes, including time to swap filament).
I recommend printing with a layer height of 0.2mm which is both good quality, and quite fast, since the model is small (should take about 40 minutes, including time to swap filament).
This model does not require rafts or supports of any kind.
Date published | 06/01/2021 |
Material Quantity | 9 grams |
Dimensions | 110x78.3x2.4 |
Support Free | YES |