Raised stand for Logitech QuickCam Pro 9000 - #wildxwyze
Raised stand for Logitech QuickCam Pro 9000 - #wildxwyze
3D
Published 2019-10-31T19:32:31+00:00
As someone who likes my monitors at eye level, I was fed-up of either having my webcam looking down at the top of my head, or being really low and looking up too much.
So I decided to improve the stand for my trusty old Logitech QuickCam Pro 9000.
The stand just has a slot on it, shaped to match the 'foot' of the built-in stand, allowing the webcam to stand much higher than is possible with the existing stand.
It prints as a single piece, with no supports needed, and the webcam just slots straight in (and is easy to remove again at any time).
I recommend printing with a moderate infill (30% or greater) and ideally at least 3 perims, just to add a little weight to it. (I think I did 3 perims at 40% infill, and that's plenty heavy/stable enough)
| Date published | 31/10/2019 |
| Time to do | 120 - 150 minutes |
| Material Quantity | 40g |
| Dimensions | 55mm x 75mm x 22mm |
| Support Free | YES |
