Replacement Front Axle Mount for a RC Model Car
Replacement Front Axle Mount for a RC Model Car
3D
Published 2015-02-11T15:39:30+00:00
When printing this design you will need support martial due to a 2mm height difference from front to rear.
This part replaced a part which was broken; So rather than buy a new one I was able to reproduce a replacement using Open SCAD and a 3D printer.
This repair enable me to place my Arduino Bluetooth controlled model car to be placed back upon it's wheels and complete it. It was printed with support material as it's about 2mm higher at the front than the back. Its thickness is about 5mm, kept the support material to provide extra strength and stiffness. Time taken to print was about 7mins.
Print at 0.2 mm layer height, with 10% infill. This uses 1 g of filament and takes 6 minutes.
| Date published | 11/02/2015 |
| Time to do | 6 - 16 minutes |
| Material Quantity | 1 g |
| Dimensions | 34 x 22 x 5 mm |
